Commercial Steering Systems

Description
This type of commercial vehicle steering system has forged yoke assembly where shafts are welded to the yokes.

The maximum and minimum total height from face to face is 88.09 and 85.34 respectively.

Description
This commercial steering system have forged yoke assembly where shaft is clamped with nuts & bolts. Our automotive clamps are made with best quality materials.

The maximum and minimum face to face height is 116.59 and 112.52 respectively.

Description
In this commercial vehicular steering system, there is forged yoke assembly where shaft is clamped with nuts & bolts at one end and welded on the other end.

The maximum and minimum total height from face to face is 116.71 and 94.94 respectively.

Description
This type of joint is used in those steering columns, which have both tilt and telescopic ranges for greater comfort & clearances. With S-Shaft joint, one has the option to adjust steering wheel at the most convenient angle for extra comfort. Moreover, there are no incremental stops due to the slip shaft.

The Compressed Length is in the range of 284.61 (Min) to 916.81 (Max) and extended length can vary from 341.76 (Min) to 993.01(Max)

Description
This shaft joint is used in a column drive, which uses sensors to determine the driving conditions. Both the shafts are made of single piece forging & machining.

The maximum and minimum total height from face to face is 293.75 and 280.47 respectively.

Description
These joints are used in those series of adjustable steering columns, which provide smooth operation with solid lash-free driving position. Infinite adjustment is available through the full range of motion.

Dimensionally, the Compressed Length is between 463.42 (Min)and 485.09 (Max) whereas the extended Length has a range of 564.26 (Min)to 675.26 (Max)

Description
We offer stub shafts for commercial vehicles, which are as per the OEM specifications. These stub shafts are available for all variants of commercial vehicles, irrespective of whether the commercial vehicles non-ABS trucks or ABS trucks.

The maximum and minimum total height from face to face is 306.6 and 145.34 respectively.

Description
Stainless steel joints are designed and developed for varied automobile models. We have expertise in OEM and aftermarket specifications. Custom product development is also our forte.

Total Height from Face to Face (Dim) is a min of 93 and max of 145. The max diameter from bearing hole to face is 48.